# Introduction lossary of Prosthodontic Terms 1 defines the occlusal vertical dimension as the distance between two selected points when the occluding members are in contact and rest vertical dimension as the distance between two selected points when mandible is in physiologic rest position. For a successful denture in terms of esthetics and function correct vertical dimension should be determined. 2 In clinical practice, there exists no universal rule for determining correct vertical dimension at occlusion because of wide range of individual variation. 3 Use of pre-extraction records, 4 maximum biting force, 5 electrymyographic method, 6 and cephalometric radiograph 7 are some of the techniques utilized for determining occlusal vertical dimension. Millet et al. 8 recommended using multiple methods, like physiologic rest position, swallowing, phonetic, esthetics and facial measurements. Distance between soft tissue landmarks of face was significantly correlated to occclusal vertical dimension. 9 Author ? ? ?: Department of Prosthodontics, B. P. Koirala Institute of Health Sciences, Dharan, Nepal. e-mail: bishal_bpkihs@yahoo.com The purpose of this study was to evaluate the correlation between facial measurements and occlusal vertical dimension in two ethnic groups of Nepal. # II. # Materials and Methods Two hundred subjects between 19 and 46 years (mean age 25 years) were randomly selected from among the students, staffs, patients and relatives of patients visiting the College of Dental Surgery, B. P. Koirala Institute of Health Sciences. They were divided into two groups according to ethnicity, Aryans and Mongoloids. The inclusion criteria were full set of dentition, straight profile on visual examination, absence of malocclusion, no history of orthodontic and prosthodontic treatment. Each subject was instructed to relax the lips and close mouth in centric relation. The occlusal vertical dimension was measured between most prominent part of chin and nose. Other facial measurements measured were the distance between pupil of eye to corner of mouth (rima oris), distance between outer canthus of one eye to inner canthus of other eye, distance between outer canthus to midpoint of external auditory meatus and vertical height of ear. Independent sample t test was performed to test the difference of means of studied parameters in males and females and in Aryans and Mongoloids. Correlation between these facial measurements and occlusal vertical dimension was studied with Pearson's correlation coefficient (r) at the significance level ?0.05 and 95% confidence interval. # III. # Results The mean occlusal vertical dimension of studied sample was 64.87±5.21 mm. In Aryans, it was mm and in Mongoloids mm. The tables 1-4 show the results of this study. It was found that males have significantly longer dimension of OVD. The difference of means of rima oris to pupil distance, vertical height of ear, distance between outer canthus of one eye to inner canthus of other eye and eye-ear distance between males and females was not statistically significant. As we compared two ethnicities (Table 3), it was found that OVD and rima oris to pupil distance were significantly longer in Mongoloids whereas eye-ear distance was significantly longer in Aryans than Mongoloids. The correlation between the facial measurements and occlusal vertical dimension was found statistically significant in both ethnicities (Table 4). However, the correlation between rima oris to pupil distance was stronger than the others. It was also noted that correlation between other facial measurements (eye-ear distance, distance between canthi and vertical height of ear) in Mongoloids was relatively weaker. Overall, rima oris to pupil distance was significantly correlated to occlusal vertical dimension (Table 5) with stronger correlation than other facial measurements. p-value significant at ?0.05 level. Sig.-significant, NS-not significant IV. # Discussion The loss of teeth results in poor appearance of lower third of face. The restoration of correct vertical dimension in those who have lost it should be in harmony with the upper part of face. Prosthodontists have long been seeking for universally accepted method of determining the OVD. There were methods like use of anterior teeth measurements 10 , closest speaking space 11 , swallowing method 12 , patient's neuromuscular perception 13 , cephalometric radiographs 14 , intra-oral and extra-oral anatomic landmarks 15 and measurement of fingers. 16 All of these methods possess some kinds of disadvantages. The present study gave some idea about facial measurement and their use in determining occlusal vertical dimension. In present study the occlusal vertical dimension was found 65.90±4.31 mm in male and 63.35±6.03 mm in female. These were found to be longer than the findigs of Ladda et al. 16 (61.4±4.2 mm in male and 56.7±3.0 mm in female) and Kulakarni and Kohli 17 (54 to 59 mm in female and 62 to 65 mm in male). The distance between ANS and Me from cephalometric radiograph in Serbian population, was 67.87±5.67 mm in male and 61.51±5.06 mm in female. 7 Similar measurements were observed in Iraqi adult population reported by Al-Hamadany 18 where occlusal vertical dimension in 75 students was 66.74±6.468 mm. The OVD in males was 68.25±6.134 mm and in females, it was 63.99±6.254 mm. These values are consistent to that of current study. The correlation was statistically significant and positive with rima oris to pupil of eye (r=0.557), followed by distance between outer canthus of one eye to inner canthus of other eye (r=0.449) and eye-ear distance (r=0.395) and vertical height of ear (r=0.378). This is in contrast with the study done by Delic et al. 19 The correlation of eye-ear distance (r=0.8676) was stronger than pupil to rima oris distance (r=0.4357) in their study. Rima-oris to pupil distance was longer than lower facial height by 3 cm in a study done in Phillipinos by Tina-Olaivar et al. 20 The limitations of the study were only two ethnic groups were taken into consideration and the findings cannot be extrapolated to other races. Also, the sample investigations to endorse or refute the findings of present study in this part of world as most of studies are found pertaining to developed countries. V. # Summary Anthropometric measurements of facial landmarks were recorded for 200 subjects (100 Aryans and 100 Mongoloids) and correlation of facial measurements to occlusal vertical dimension was tested. Within the limitations of this study, we can conclude that the facial measurements are significantly correlated to the occlusal vertical dimension. Findings of this study will be helpful guide in determination of occlusal vertical dimension. size was very small to conclude the findings. The occlusal vertical dimension is not constant and dynamic. Therefore the anthropometric measurement in dentulous subjects can be an adjunct but not accurate for utilizing in edentulous patients. There need to be further 1![Figure 1 : Measurement of OVD by Boley gauge](image-2.png "Figure 1 :") 23![Figure 2 : Measurement of distance from rima oris to pupil of eye](image-3.png "Figure 2 :Figure 3 :") 4![Figure 4 : Measurement of eye-ear distance](image-4.png "Figure 4 :") 5![Figure 5 : Measurement of vertical height of ear](image-5.png "Figure 5 :") 1Character NumberMinimum MaximumMeanStd. deviationAge2001946254.78OVD200487764.875.21RO-Pu20052.57264.774.65OC-IC200557766.993.74E-E200538269.324.17EH20048.47160.253.75 2ParametersGenderNMean±S.D. p value RemarksOVDMale Female120 8065.90±4.31 63.35±6.030.001Sig.RO-PuMale Female120 8064.78±4.43 64.77±4.980.437NSOC-ICMale Female120 8067.27±3.40 66.57±4.190.053NSE-EMale Female120 8070.33±3.91 67.83±4.110.967NSEHMale Female120 8060.93±3.75 59.23±3.550.421NSp-value significant at ?0.05 level. Sig.-significant, NS-not significant 3Parameters EthnicityNMean±S.D. p value RemarksOVDAryan Mongoloids 100 65.86±3.61 100 63.89±6.29<0.001Sig.RO-PuAryan Mongoloids 100 66.90±3.56 100 62.65±4.650.003Sig.OC-ICAryan Mongoloids 100 67.56±3.45 100 66.42±3.950.062NSE-EAryan Mongoloids 100 68.54±3.24 100 70.12±4.81<0.001Sig.EHAryan Mongoloids 100 60.21±3.75 100 60.29±3.780.200NSp-value significant at ?0.05 level. Sig.-significant, NS-not significant 4YearVolume XIV Issue VI Version I( ) JAryansMongoloidsMeasurements Pearson's rp-valueSignificancePearson's rp-valuesignificanceOVD11RO-Pu0.577<0.001Sig.0.466<0.001Sig.OC-IC0.508<0.001Sig.0.3070.002Sig.E-E0.498<0.001Sig.0.3200.001Sig.EH0.471<0.001Sig.0.2780.005Sig.p-value significant at ?0.05 level. Sig.-significant, NS-not significant 4MeasurementsPearson's rp-valueSignificanceOVD1RO-Pu0.557<0.001Sig.OC-IC0.499<0.001Sig.E-E0.395<0.001Sig.EH0.378<0.001Sig. © 2014 Global Journals Inc. (US) * The glossary of prosthodontics terms J Prosthet Dent 94 1 2005 Jul * Syllabus of complete dentures. 2 nd ed CMHeartwell AORahn Philadelphia: Lea & Febiger 1974 * Vertical dimension and its correlation with lip length and interocclusal distance WWHurst J Am Dent Assoc 64 1962 * Pre-extraction records for complete denture fabrication: a literature review MBissau J Prosthet Dent 91 1 2004 Jan * Intermaxillary relation established by biting power RHBoos J Am Dent Assoc 27 1940 * Comparison of physiologic methods of determination of occlusal vertical dimension in edentulous persons ZMiljcovic MZeljkovic MAnojcic Vojnosanit Pregl 58 4 2001 Jul-Aug * Cephalometric indicators of the vertical dimension of occlusion LStrajnic DStanisic-Sinobad DMarkovic LStojanovic Coll Antropol 32 2 2008 * Vertical dimension in the treatment of edentulous patient CMillet ALeterme CJeannin PJaudoin * Rev Stomatol Chir Maxillofac 111 5-6 2010 Nov-Dec. * Correlation of vertical dimensions of soft tissue facial profiles AKAl-Hamdany NHKassab Al-Rafidain Dent J 10 2 2010 * Influence of lower lip support on recording of vertical dimension in edentulous patients AEkfeldt SKarlsson J Oral Rehabil 19 1992 * The speaking method in measuring vertical dimension MMSilverman J Prosthet Dent 3 2 1953 Mar * Physiologic vertical dimension and centric relation TejShanahan J Prosthet Dent 6 1956 * Vertical relation of occlusion by the patient's neuromuscular perception RBLytle J Prosthet Dent 14 1 1964 Jan-Feb * Cephalometric analysis of the vertical dimension of occlusion FLBasler JRDouglas RSMoulton J Prosthet Dent 11 1961 * Determination of occlusal vertical dimension: a literature review FFayz AEslami J Prosthet Dent 59 3 1988 Mar * A new technique to determine vertical dimension of occlusion from anthropometric measurements of finger RLadda AJBhandari VOKasat GSAngadi Indian J Dent Res 24 2013 * Estimation and correlation of individual facial height and total body height NKulkarni MKohli J Int Oral Health 3 2 2011 Apr * Correlation of vertical dimensions of soft tissue facial profiles AKAl-Hamdany NHKassab Al-Rafidain Dent J 10 2 2010 * Evaluation of craniometric methods for determination of vertical of occlusion ZDelic MSimunovic-Soskic RPerinic-Grzic SVukovojac ZRajic TKuna Coll Antropol 1 2000 suppl. 24 * A comparative study of the upper and lower vertical facial measurements of the Filipinos as it is used in the Willis method for determining the vertical dimension of occlusion EOTina-Olaivar OKOlaivar J Philipp Dent Assoc 50 1 1998 Jun-Aug